Comments
Hi, I built this schematic, however it does not work quite riht.
issue #1
there are random towers in the hole, where it did not drill:
issue # 2
the drill does not automatically go down, because it did not drill where it starts (where it goes down, then i spins i hve to use the drill up/down controll to make a hole, then it works:
pic of starting obstruction:
and i will include a photo of where my pilot hole is (I am standing in it)
Either drill is spinning too fast to break the blocks or server is lagging a bit, mspt might be higher. Set the rotational speed control to a slow speed to test
I am not on a server, singleplayer FPS might be 40-65.
Will try slowing drill today, though.
Even in single player minecraft runs as a client-server setup.
Not FPS ... tps and mspt. These indicate how well the server is running, or lagging.
tps was always 20, lowering the drill speed from 8rpm to 6 rpm, made the random towers go away, but still doesnt go down.
